The centrifugal separator is a centrifugal effect, separating the liquid and solid particles or liquids in the mixture of liquid and liquid, also known as centrifuge.
The centrifugal separator is mainly used to separate the solid particles in the suspension from the liquid; or separate two densities in the emulsion, and unpainless liquid (for example from milk); it can also be used Exhas liquid in wet solids, such as dry and wet clothes with a washing machine; a special overspeed gas separator can also separate different density gas mixtures, such as concentration, separating gaseous hexafluoride uranium; using different density or particle size solid particles The settlement speed in the liquid is different, and some settled centrifuges can be classified by density or particle size. A large number of centrifugal separators are applied to chemical, petroleum, food, pharmaceutical, mineralization, coal, water treatment, and ships.
Industrial centrifugal separators can be divided into filtration centrifuges, settled centrifuges and separators. The separator is only suitable for separating low concentration suspensions and emulsions, including dish separators, tubular separators, and chamber separators.
Feed: When the frequency of frequency is 30 Hz, the feed valve is opened. When the material is filled, the feed valve is turned off, and the latency is 208, solid, the liquid is automatically separated. At this time, the material layer will automatically drop, and when the material is filled with the signal, turn on the feed valve again, and then load it again The solid and liquid mixture to be separated, repeat the above operation, and continuously perform 3 times.
Solid separation: When the third charge full signal is generated, the buffer valve is closed, the frequency of the frequency converter is rising to 50 Hz for high speed separation, and the centrifugal time is set by the touch screen. After the time is reached, the frequency is reduced to 40 Hz.
Cleaning Dry (This action is selected according to the separation): Open the cleaning valve for cleaning, cleaning time, pause time, and cleaning of the number of times of cleaning can be set by touch screen depending on the separated item. After the cleaning process is completed, enter the dried process. At this time, the frequency converter rises to 50 Hz, and the time is set by the touch screen. After drying, the discharge process is transferred. Unloading: Since the dry rear material is too thick, the doctor blade uses a segment timing rotary unloading, that is, the blade rotation (time can be set) a stop of 4S a doctor blade, repeating the above operation, until the last scraper drops to the limit position After the touched limit switch, it rises to the top and triggers the upper limit switch to stop.
